Programmable linear Hall Sensors HAL 880

The HAL 880 is designed to fulfil the requirements of
today‘s state-of-the-art applications for linear and angular
measurements that require flexibility to compensate system tolerances.
Due to its programmability, it also offers the additional
advantage of compensation of system tolerances. This is mandatory
for applications like accelerator pedal sensing, current
measurement, bending light or head light adjustment.
The sensor provides a linear, ratiometric analog output signal
with implemented wirebreak detection working with pull-up or
pull-down resistor.
Major characteristics like magnetic field range, sensitivity, VOQ
(output voltage at zero magnetic field) and the temperature coefficients can easily be adjusted to the magnetic circuit (linear
and quadratic) by programming the non-volatile memory.
The HAL 880 is available in a very small leaded package
TO92UT.

Features

» Sensitivity drift over temperature less than ±6 %

» Offset drift over temperature less than ±15 μT/K

» Integral non-linearity error of output signal ±1 %

» Low output noise of 25 mV peak-peak

» Wire-break detection with 5 kΩ pull-up or pull-down resistor

» Four programmable magnetic ranges:

   ±30, ±60, ±80, and ±100 mT

» Two programmable 3 dB filter frequencies:

   500 Hz and 1 kHz

» Programmable sensitivity and offset (VOQ )

» 12-bit ratiometric analog output

» Digital signal processing

» Temperature characteristics programmable to match all

   common magnetic materials

» 13 customer data bits

» Programming by modulation of the supply voltage

» Junction temperature: -40°C ... +140°C

» Supply voltage: 4.5 V ... 5.5 V

 

Applications

» Linear movement

» Current measurements

» Rotary position measurements

» Level measurement